Landa Concrete Remover

Concrete Remover effectively removes concrete splatters and deposits from construction vehicles, equipment, tools and commercial surfaces. Not intended for use on fine automotive finishes. Always pre-test undiluted product in an inconspicuous area, to determine safety and suitability for the intended use.

• 1:1, 5 gallons makes 10 gallons

To Apply: Spray diluted solution on surface and allow to penetrate, but not dry. Apply detergent from the bottom up and rinse from the top down.

Directions: INDUSTRIAL USE ONLY. Read the Safety Data Sheet thoroughly before using this product. Do not pre-wet surfaces to be treated, as this will decrease the rate of concrete removal. Apply Concrete Remover undiluted to affected areas, using a pump sprayer or a soft chemical-resistant bristle brush. For fresh light splatters, dilute product 1:1 (pH 2.0 at dilution). Allow 15 minutes dwell time for concrete to soften. Rinse surfaces thoroughly with fresh clean water. Use of a high pressure washer will assist with removal and rinsing. Allow all surfaces to dry before the re-treatment of any heavier concrete deposits.

• Safe for Use on Most Painted Metal Surfaces
• Save Time by Working Fast
• Economical - Can be Diluted 1:1 for Fresh Light Splatters
• Phosphate Free

• Color: Light Yellow
• Scent: Sharp
• Foam 1-5: 3 = Medium
• Reaction in Hard Water 1-5: 3 = Average
• pH at Full Strength: 2.2
• pH at use Dilution(1:1 ratio): 2.0

5 Gal 8.698-181.0

55 Gal 8.698-182.0